Things to check:
Run a self test from the front panel to eliminate your computer or software from the equation
Try different cards
Ensure that the cards you are using are in specification
Manually clean the rollers
Update the printer driver and firmware to the latest on Fargo’s Website
Check to make sure that the printer is on a completely level service
Remove and test the printer without the other modules. Then reattach the flipper and lamination module (The tabs can become bent and cause the modules to not align properly. You can attempt to bend them back into the correct position)
Ensure that the flipper module and lamination module are correctly attached and fastened with the screws
Check for card warpage (If the card is warped in the transfer process the card will most likely jam going into the flipper module)
